|
Substrates |
Dried and sanded existing finishes and putty. |
|
|
SurfaceCleaning |
Wash by warm soap, remove wax, silicon and other contaminations with degreaser, sanding with P800-P1000, wash with clean water then keep dry; again with degreaser. |
|
|
MixingRatio |
F400-1Kprimer surfacer |
Thinner |
| 1 | 1 | |
|
A 、＜15℃ ：90 Fast Thinner； B 、 15-30℃：91 Standard Thinner； C、＞30℃：92Slow Thinner |
||
|
SprayViscosity |
14-16s to drop off, in4# viscosity cup at 25°C, |
|
|
Spray GunSet Up |
Gravity Feed: 1.2-1.5mm 4-5kg/cm 2 Suction Feed: 1.4-1.6mm 4-5kg/cm 2 |
|
|
SprayTechnology |
Coats&Thickness: 2-3 coats, total 20-30um. Flash-Off Time: At 25°C, 5-10 minutes between two coats, it depends on temperature and paint film. |
|
|
Drying Time |
Air-drying time 30 minutes, at 20°C. |
|
|
Shelf Life |
2 years in original sealed can, cool and dry place at 20℃. |
|
|
Package |
3.75L×4 |
|
Note:
1. The substrate must be cleaned and sanded before spray, wet sanding P800-1000 and then dry.
2. At ambient temperature higher than 30℃, add appropriate Retarder Solvent into thinner to avoid blushing. For more details, please refer to technical data sheet of Retarder Solvent.
3. Not recommended to apply over large area.
4. Not recommended for direct application over substrate of bare metal, stainless steel, aluminium,zinc, steel and wood.
